Terex Genie Z-45 DC, Service And Repair Manual, Page: 55 / 140

July 2020
Part No. 1297714GT Z ® -45 DC • Z ® -45 FE 45
Service and Repair Manual
Ground Control
Recovery is only to be used as a last attempt to
lower the platform when control system failures or
CAN communication failures occur.
WARNING
Bodily injury hazard. When
using recovery mode, the
platform may not fully lower to
the ground when the recovery
mode is completed. Failure to
use only suitable equipment
and/or practices to allow the
operator to safely exit the
platform could result in death or
serious injury.
The Recovery switch allows the platform to be
lowered in case of control system severe fault or
CAN communication loss. The recovery switch
permits to retract the primary boom and lower the
primary and secondary booms at the same time,
using the main pump at reduced speed to allow
the operator to exit the platform.
1 In case of CAN communication loss or control
system failure only, turn off the machine, wait
at least two seconds and turn the key switch in
GROUND position.
2 Press and hold the function enable button and
move the Recovery switch backward to lower
the primary and secondary booms or move the
Recovery switch forward to retract the primary
boom.
Note: The switch must be held in the recovery
position until the recovery sequence is complete or
until the operator in the platform can safely exit the
platform.
3 If the recovery function has been used, this
indicates major faults with the main control
system and/or CAN bus. Tag and remove the
machine from service until the faults have been
fixed by trained personnel.