Terex Genie Z-45 DC, Service And Repair Manual, Page: 27 / 140

July 2020
Part No. 1297714GT Z ® -45 DC • Z ® -45 FE 17
Service and Repair Manual
8 Momentarily activate the drive enable toggle
switch in the right direction until CALIBRATE
TILT SENSOR is shown on the display.
9 Momentarily activate steer in the right direction
to choose either RAMP UP TIME or RAMP
DOWN TIME sub menus.
10 Momentarily activate the drive enable toggle
switch in the right direction to enter the desired
ramp time calibration sub menu.
11 Momentarily activate the boom function to be
adjusted.
Result: The display shows the name of
the function, direction, and time value in
milliseconds. Example "PRI_UP_VALVE 2500"
(2500 milliseconds / 2.5 seconds of ramp time).
Note: At this step, the function can be tested and
ramp times can be measured. Release the foot
switch prior to making a parameter adjustment.
12 Momentarily active steer to change the ramp
up or ramp down value. Each activation will
change the value by 50 milliseconds. Refer to
the Ramp Rate chart for factory settings.
13 Momentarily activate drive enable switch right
to save the value.
Result: The alarm will sound indicating the
setting has been saved. Continue to the next
desired Ramp time adjustment.
Ramp up time (factory settings)
Primary boom up/down
ramp accelerate (up)
ramp decelerate (down) 2 seconds
0.6 second
Secondary boom up/down
ramp accelerate (up)
ramp decelerate (down) 2.5 second
0.5 second
Turntable rotate
ramp accelerate (up)
ramp decelerate (down) 1.5 seconds
1.25 seconds
Extend/Retract
ramp accelerate (up)
ramp decelerate (down) 2 seconds
0.4 second
Jib up/down
ramp accelerate (up)
ramp decelerate (down) 2 second
0.4 second
Platform rotate
ramp accelerate (up)
ramp decelerate (down) 0.75 second
0.3 second
Propel
ramp accelerate (up)
ramp decelerate (down) 5 seconds
3 seconds
Platform Controls