Terex Genie Z-45 DC, Service And Repair Manual, Page: 40 / 140

30 Z
®
-45 DC • Z
®
-45 FE Part No. 1297714GT
July 2020 Service and Repair Manual
Primary Boom Components
NOTICE
Component damage hazard.
The boom cable track can be
damaged if it is twisted.
Note: A 7 link repair section of cable track is
available through the Genie Service Parts
Department.
1 link separation point
2 lower clip
1 Use a slotted screwdriver to pry down on the
lower clip.
2 To remove a single link, open the lower clip
and then use a screw driver to pry the link to
the side.
3 Repeat steps 1 and 2 for each link.
WARNING
Bodily injury hazard. This
procedure requires specific
repair skills, lifting equipment
and a suitable workshop.
Attempting this procedure
without these skills and tools
could result in death or serious
injury and significant component
damage. Dealer service is
strongly recommended.
Note: Perform this procedure with the boom in the
stowed position.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications,
Hydraulic Hose and Fitting Torque
Specifications.
1 Remove the platform.
2 Remove the jib boom. Refer to Repair
Procedure, How to Remove the Jib Boom.
3 Remove the cable track. Refer to Repair
Procedure, How to Remove the Cable Track.
4 Raise the primary boom to a horizontal
position.
5 Remove the hose and cable cover from the
upper pivot.