Terex Genie Z-33/18, Service And Repair Manual

Page: 39 / 117

January 2020
Part No. 1268514GT Z
®
-33/18 3-17
Section 3 • Repair Procedures
Primary Boom Components
The primary boom cable track guides the cables
and hoses running up the boom. It can be repaired
link by link without removing the cables and
hoses that run through it. Removing the entire
primary boom cable track is only necessary when
performing major repairs that involve removing the
primary boom.
WARNING
Component damage hazard.
The primary boom cable track
can be damaged if it is twisted.
1 Use a slotted screwdriver to pry down on the
lower clip.
2 Repeat step 1 for each link.
3 To remove a single link, open the lower clip.
Use a screwdriver to pry the link to the side.
a
b
H I J K L M N O H P H Q J R K O R J K Q
S
I R T N P U I J O
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation.
Refer to Section Two,
Hydraulic Hose and Fitting
Torque Specifications .
1 Working at the turntable, locate the two wire
cables which are routed to the platform through
the bottom side of the secondary boom.
a mid pivot
b cable tray
c cable track
d cable bridge
e secondary boom
f turntable
g platform mount
2 Tag and disconnect one of these wire cables
from their source at the ground control box.
b a
YY
XX
c d e f
g