Terex Genie Z-33/18, Service And Repair Manual

Page: 33 / 117

January 2020
Part No. 1268514GT Z
®
-33/18 3-11
Section 3 • Repair Procedures
PLATFORM CONTROLS
Adjusting the max speed setting will only affect the
stowed drive speed. Elevated drive speed is not
adjustable.
Begin this procedure with the machine in the
stowed position.
1 Turn the key switch to platform control.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Move and hold the drive enable toggle switch in
the right direction while holding the steer rocker
switch in the right direction.
4 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer rocker switch.
Result: The display will show FAULTS .
5 Momentarily activate the steer rocker switch in
the right direction until SETTINGS is shown on
the display.
6 Momentarily activate the drive enable toggle
switch in the right direction until VALVE AND
PUMP SETTINGS is shown on the display.
7 Momentarily activate the steer rocker
switch in the right direction until you see the
AUTHORIZATION screen.
8 Momentarily activate the drive enable toggle
switch in the right direction to enter the
authorization screen.
9 Using the rocker switch on the drive joystick,
momentarily activate steer left, left, right, and
left.
Result: The alarm will sound.
10 Momentarily activate the steer rocker switch
in the right direction until you see the DRIVE
SETTINGS screen.
11 Momentarily activate the drive enable toggle
switch in the right direction to enter the DRIVE
SETTINGS menu.
Result: The display will show ACCEL RAMP .
12 Momentarily activate the steer rocker switch in
the right direction until you see the MAX SPEED
screen.
13 Momentarily activate the drive enable toggle
switch in the right direction to enter the MAX
SPEED menu.
14 Create start and finish lines by marking two
lines on the ground 40 feet / 12.2 m apart.
15 Choose a point on the machine; i.e., contact
patch of a tire, as a visual reference for use
when crossing the start and finish lines.
16 Bring the machine to maximum drive speed
before reaching the start line. Begin timing
when your reference point on the machine
crosses the start line.