Terex Genie Z-135/70, Service And Repair Manual

Page: 183 / 244

October 2018 Service and Repair Manual
Axle Components
Part No. 1268557GT Z®-135 /70 169
18 Press the plus button to select YES, then
press the enter button to accept.
19 Press the enter or previous button on the
LCD screen until EXIT is displayed.
20 Press the plus button to select YES, then
press the enter button to accept.
21 Press and hold the engine start button for
approximately 5 seconds to shut off the engine
and to save the calibration settings.
Note: Do not turn the engine off with the key switch
or red Emergency Stop button or all calibration
points or values will not be saved.
22 Wait approximately 20 seconds and turn the
machine off by pressing the red Emergency
Stop button in.
Before serial number 321:
23 Remove the wire jumper from the 2 pin
connector in the lower left hand area of the
ground control box that was installed in step 8.
Install the connector plug.
Tip-over hazard. Failure to
remove the jumper wire will
result in an unsafe configuration
which will compromise machine
stability. Operating the machine
in this configuration will result in
the machine tipping over,
resulting in death or serious
injury. The jumper wire must be
removed before operating the
machine.
24 Close the ground control box and install the
door retaining fasteners.
After serial number 320:
25 Remove the fastener that was temporarily
installed. Close the control box door and install
the door retaining fasteners.
Note: When the control box door is closed, the
calibration toggle switch is automatically activated
to exit out of calibration mode.
All models:
26 Turn the key back to the run position and
remove the key from the bypass/recovery key
switch. Insert the key into the main key switch
and turn it to ground controls.
Note: Be sure that the bypass/recovery key switch
is in the run position before attempting to operate
the machine.