Terex Genie Z-135/70, Service And Repair Manual

Page: 121 / 244

October 2018 Service and Repair Manual
Display Module
Part No. 1268557GT Z®-135 /70 107
Screen or Menu Procedure Description Range or Selection
Machine Status With key switch on, press the
(plus)(minus) buttons at the same
time.
Hydraulic pressure PSI
(English) 0-4500 PSI
Hydraulic pressure kPa (metric) 0-31000 kPa
Primary boom to secondary
boom angle +22° to +136°
Primary boom length =0', >0', >22
Secondary boom angle* -3.5° to 76°
Secondary boom length =0FT, >0 FT
Jib bellcrank angle -10° to +10°
*(referenced to chassis
tilt angle)
DPF Regeneration Mode
(Auto / Force / Inhibit)
Unit of Measure
and Language
With key switch
OFF
, press and hold
the enter button and turn key switch to
on position.
Release the
enter button and press
(plus)(minus)(minus)(plus) .
Metric/English (measurement
units) English, German,
French, Spanish,
Portuguese, Italian,
Dutch, and Swedish.
Set engine Deutz TD2011L04i
(DL04i)
Perkins 1104D-44T
(P1104)
Overload Recovery
(software V3.07 and later) Clear Overload Recovery YES/NO
A passcode is required
to clear the message
Default Reset
With key switch
OFF
, press and hold
the enter button and turn key switch to
on position.
Release the
enter button and press
(minus)(minus)(previous)(previous)
Delete drive functions
Software version
3.11 or lower
and software
version 4.01 Delete boom function speed
Delete lift function ramps
Delete all (Contact Genie
Product Support before using
this option)
Delete Faults Delete faults will reset
active latching faults.
Delete faults will not
clear fault history.