Terex Genie SX-150, Service And Repair Manual

Page: 85 / 282

December 2019 Service and Repair Manual
Ground Controls
Part No. 1300669GT SX ™ -150 73
3 Turn the bypass/recovery key switch to the
bypass position.
4 Using auxiliary power, operate the ground
control buttons to level the platform.
Note: Only the auxiliary power unit can be used to
correct an out of level platform fault.
5 Turn the bypass/recovery key switch to the run
position.
6 Remove the key from the bypass/recovery key
switch and insert the key into the main key
switch.
Note: If the Bypass function has been used, there
may be faults with the machine. Check the LCD
screen on the ground control box for machine faults,
then contact trained service personnel.
How to Use the R ecovery Mode How to Use the Recovery Mode
Recovery is only to be used as a last attempt to
lower the platform when the operator in the
platform is unable to do so, system failure or in
emergency situations.
Bodily injury hazard. When using
recovery mode, the platform may
not fully lower to the ground when
the recovery mode is completed.
Failure to use only suitable
equipment and/or practices to
allow the operator to safely exit
the platform could result in death
or serious injury.
Bodily injury hazard. Platform
leveling is not active when using
recovery mode. The platform
could reach high out-of-level
conditions when using this mode.
The operator will need to secure
themself to the platform to
prevent falling injury.
The recovery sequence will automatically retract
the primary boom and then lower the primary boom
using the auxiliary power unit to allow the operator
at the platform controls to exit the platform.
1 Turn the main key switch to ground controls.
Remove the key from the main key switch and
insert the key into the bypass/recovery key
switch.