Terex Genie SX-150, Service And Repair Manual

Page: 39 / 282

December 2019 Service and Repair Manual
Platform Controls
Part No. 1300669GT SX ™ -150 27
Function speeds:
Note: Be sure the machine is in the stowed position
and the boom is rotated between the circle end
tires.
Note: Perform this procedure with the machine on
a firm, level surface that is free of obstructions.
12 Start the engine from the platform controls.
13 Select the function that needs the function
speeds set.
14 Primary boom extend/retract functions:
Move the joystick full stroke in the extend
direction. When the alarm sounds, move the
joystick in the opposite direction full stroke
until the alarm sounds again. Return the
joystick to center.
Turntable rotate functions: Move the
joystick full stroke in either the left or right
direction. When the drive enable indicator light
turns on, move the joystick in the opposite
direction full stroke until the alarm sounds.
Return the joystick to center.
Extend the boom approximately 4 ft / 1.2 m,
then again move the joystick full stroke in the
opposite direction until the alarm sounds.
Return the joystick to center.
Raise and extend the boom approximately
85 ft / 26 m, then again move the joystick full
stroke in the opposite direction until the alarm
sounds. Return the joystick to center.
15 Once the function speeds have been set,
press and hold the engine start button until the
engine shuts off. Do not press the red
Emergency Stop button.
Note: Approximately 3 seconds after the engine
shuts off, the alarm at the ground controls will
sound to indicate the settings are being saved in
memory.
16 At the ground controls, turn the key switch to
the off position, wait a moment and then turn
the key switch to platform controls.
17 Check the display at the ground controls to be
sure there are no calibration faults.
Note: There should be no calibration faults shown
on the display. If calibration faults exist, repeat this
procedure.