Terex Genie SX-150, Service And Repair Manual

Page: 46 / 282

Service and Repair Manual December 2019
Platform Components
34 SX ™ -150 Part No. 1300669GT
11 Press the enter or previous button on the
LCD screen until EXIT is displayed.
12 Press the plus button or minus button to
select YES and then press the enter button.
13 Remove the fastener that was temporarily
installed. Close the control box door and install
the door retaining fasteners.
Note: When the control box door is closed, the
calibration toggle switch is automatically activated
to exit out of calibration mode.
2-5
Platform Overload System
Proper calibration of the platform overload system
is essential to safe machine operation. Continued
use of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform. The stability of the
machine is compromised and it could tip over.
How to C alibr ate the Pl atform Overl oad System How to Calibrate the Platform
Overload System
Note: Perform this procedure with the machine on
a firm, level surface and in the stowed position with
the axles extended.
1 Fully retract the boom and jib boom. Level the
platform.
2 Remove all equipment or tools from the
platform. Remove the welder if equipped.
3 Determine the maximum platform capacity.
Refer to the machine serial plate.
4 Push in the ground controls red Emergency
Stop button to the off position.
5 Turn the key switch to ground controls.
6 Open the ground control box.
7 Locate the calibration toggle switch at the top
of the ground control box. Activate calibration
mode by moving the toggle switch in the left
direction.
8 Temporarily install a control box door retaining
fastener between the door and the box to
prevent the control box door from moving the
toggle switch while calibrating the machine.