Instructions
Rev C
Light Towers - AL™, RL™ Models
66
Lift Connect
™
Part No. 1295251GT
RL4 Vertical Mast
This procedure only applies to the following serial
numbers listed below.
from serial number
RL415-101
Note: Perform this procedure on a firm, level
surface.
1 Open the engine compartment.
2 Using a mild cleaning solvent, clean the top of
the chassis between the battery and ground
controls compartment.
1 telematics bracket
2 battery
3 ground controls compartment
3 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
4 Adhere the bracket to the top of the chassis.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
5 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT or 1289522GT.
1 retaining fasteners
2 telematics module
3 telematics bracket
6 Connect the telematics module to the retrofit
harness.
Genie part number 1292198GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
