Instructions
Rev C
Procedure - S
®
and Z® Booms
32
Lift Connect
™
Part No. 1295251GT
Updating the Machine Software
Note: The Plus+1 Service Tool must be
installed on your computer.
1 Go to the Genie Firmware site. From the drop
down
menu under
Machine Model
, select the
model that is appropriate for your machine.
Select
Search
.
2 Under
Application Firmware
, open the
.zip
file and save the
.lhx
file for
Controller Type
PCON
and
TCON
to your desktop.
3 Update the machine software.
4 After the software is updated, navigate to the
Options menu on the machine and verify that
Lift Connect (Telematics) is enabled.
Register and activate the telematics
module. Refer to page 7.
Z-62/40
This procedure only applies to the following serial
numbers listed below.
from serial number
Z6215A-101 to Z62H-4366
Z6216D-101
Z6216M-101
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Using a mild cleaning solvent, clean the left
side of the ground control box.
1 telematics bracket
2 ground control box
2 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
3 Adhere the bracket to the control box.
Note: Mount the bracket 1.125 inch / 2,86 cm from
the top of the control box.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
