Instructions
Rev C
Procedure - S
®
and Z® Booms
8
Lift Connect
™
Part No. 1295251GT
6 Connect the loose end of the retrofit harness
to the 8 pin connector located on the right side
of the control box.
1 telematics module
2 connector, 8 pin
7 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
8 Locate the machine serial label.
9 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
10 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Register and activate the telematics
module. Refer to page 7.
S-60, S-65, S-60X, S-60XC, S-80,
S-80X, S-85 (includes TraX™
models)
This procedure only applies to the following serial
numbers listed below.
from serial number
S6015A-29307 to S60H-40454
S60X15A-29317 to S60XH-40455
S60XC15A-29318 to
S60XCH-45000
S60TX15A-29357
S6015D-204
S6015H-35001
S6515A-30300
S6515H-35001
S8015-12562
S80X15-12470
S8515-12471
S8015D-101
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Using a mild cleaning solvent, clean the top of
the ground control box.
1 telematics bracket
2 ground control box
