Instructions
Rev C
Procedure - S
®
and Z® Booms
18
Lift Connect
™
Part No. 1295251GT
Z-34/22 DC, Z-34/22N
This procedure only applies to the following serial
numbers listed below.
from serial number
Z3415-10371
Z34N15-11814 to Z34NF-15529
Z3415D-101 to Z34ND-1147
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Open the turntable cover on the ground
control side of the machine.
2 Using a mild cleaning solvent, clean the area
of the bulkhead where the telematics device
will be mounted.
1 level sensor
2 bulkhead
3 telematics bracket
3 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
4 Adhere the bracket to the bulkhead.
Note: Mount the bracket so the top is the same
height as the level sensor mounting bracket.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
5 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT.
1 telematics bracket
2 telematics module
3 retaining fasteners
6 Connect the telematics module to the retrofit
harness.
Genie part number 1293476GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
