Instructions
Rev C
Procedure - S
®
and Z® Booms
12
Lift Connect
™
Part No. 1295251GT
7 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
8 Locate the machine serial label.
9 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
10 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Updating the Machine Software
Note: Loading software onto your computer
requires that you must have administrative
rights to download executable files.
Note: A USB flash drive is required to perform this
procedure.
1 Go to the Genie Firmware site. From the drop
down
menu under
Machine Model
, select the
model that is appropriate for your machine.
Select
Search
.
2 Under
Application Firmware
, open the
.zip
file and print or save the
ALC-600 Software
Update
instructions
1295343GT
.
3 Follow the installation instructions to update
the machine software.
Note: Both the
Application Firmware
and
Bootloader Firmware
must be updated.
4 After the software is updated, navigate to the
Options menu on the machine and verify that
Lift Connect (Telematics) is enabled.
Register and activate the telematics
module. Refer to page 7.
S-100, S-100HD, S-120, S-120HD,
SX-105 XC, SX-125 XC, SX-135
XC, SX-150, SX-180, Z-80/60,
ZX-135/70
This procedure only applies to the following serial
numbers listed below.
from serial number
S10014D-845
S100HD14D-200
S12014D-963
S120HD14D-205
SX105D-174 to SX105D-782
SX125D-101 to SX125D-820
SX135H-101 to SX135H-446
SX15015H-101 to SX150H-595
SX18014-150 to SX180H-702
Z8015-5353 to Z80H-7416
ZX13515-2646 to ZX135H-4471
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Using a mild cleaning solvent, clean the top of
the telematics connector box.
1 telematics bracket
2 telematics connector box
3 ground control box
