Instructions
Rev C
Light Towers - AL™, RL™ Models
64
Lift Connect
™
Part No. 1295251GT
6 Route the loose end of the retrofit harness into
the cabinet through the access hole.
1 telematics module
7 Open the ground control side of the cabinet
and locate the 8 pin connector in the harness
from the ground control box.
8 Connect the loose end of the retrofit harness
to the 8 pin connector.
9 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
10 Close the cabinet.
11 Locate the machine serial label.
12 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
13 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Register and activate the telematics
module. Refer to page 7.
RL4 LED
This procedure only applies to the following serial
numbers listed below.
from serial number
RL4LJ-101
Note: Perform this procedure on a firm, level
surface.
1 Open the engine compartment.
2 Using a mild cleaning solvent, clean the inside
top of the cover below the ground controls.
1 ground controls
2 telematics bracket
3 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
4 Adhere the bracket to the cover.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
