Rev C
Instructions
Light Towers - AL™, RL™ Models
Part No. 1295251GT
Lift Connect
™
59
Light T ow ers - AL™, R L™ Models
AL4, AL4L, AL5L
This procedure only applies to the following serial
numbers listed below.
from serial number
AL415-2878
AL4L15-181
AL5L15-127
Note: Perform this procedure on a firm, level
surface.
1 Using a mild cleaning solvent, clean the front
of the cabinet.
1 telematics bracket
2 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
3 Adhere the bracket to the front of the cabinet.
Note: Mount the bracket 8 inches / 20 cm down
from the top of the cabinet.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
4 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT or 1289522GT.
1 telematics bracket
2 telematics module
3 retaining fasteners
5 Connect the telematics module to the retrofit
harness.
Genie part number 1292198GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
