DE10-Lite
User Manual
39
www.terasic.com
May 11, 2018
3
3
.
.
1
1
0
0
U
U
s
s
i
i
n
n
g
g
A
A
c
c
c
c
e
e
l
l
e
e
r
r
o
o
m
m
e
e
t
t
e
e
r
r
S
S
e
e
n
n
s
s
o
o
r
r
The board comes with a digital accelerometer sensor module (ADXL345), commonly known as
G-sensor. This G-sensor is a small, thin, ultralow power assumption 3-axis accelerometer with
high-resolution measurement. Digitalized output is formatted as 16-bit in two’s complement and
can be accessed through SPI (3- and 4-wire) and I2C digital interfaces.
With GSENSOR_CS_N signal to high, the ADXL345 is in I2C mode. With the GSENSOR_SDO
signal to high, the 7-bit I2C address for the device is 0x1D, followed by the R/W bit. This translates
to 0x3A for a write and 0x3B for a read. An alternate I2C address of 0x53 (followed by the R/W bit)
can be chosen by low the GSENSOR_SDO signal. This translates to 0xA6 for a write and 0xA7 for
a read.
More information about this chip can be found in its datasheet, which is available on manufacturer’s
website or in the directory
\Datasheet\G-Sensor
folder of DE10-Lite system CD.
Figure 3-24
shows the connections between the accelerometer sensor and MAX 10 FPGA.
Table
3-13
lists the pin assignment of accelerometer to the MAX 10 FPGA.
Figure 3-24 shows the connections between the accelerometer sensor and MAX 10 FPGA.
