DE10-Lite
User Manual
17
www.terasic.com
May 11, 2018
Chapter 3
Using the Starter Kit
This chapter provides instructions to use the board and describes the peripherals.
3
3
.
.
1
1
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
o
o
f
f
M
M
A
A
X
X
1
1
0
0
F
F
P
P
G
G
A
A
o
o
n
n
D
D
E
E
1
1
0
0
-
-
L
L
i
i
t
t
e
e
There are two types of configuration method supported by DE10-Lite:
1.
JTAG configuration: configuration using JTAG ports.
JTAG configuration scheme allows you to directly configure the device core through JTAG pins -
TDI, TDO, TMS, and TCK pins. The Quartus II software automatically generates .sof files that are
used for JTAG configuration with a download cable in the Quartus II software program.
2.
Internal configuration: configuration using internal flash.
Before internal configuration, you need to program the configuration data into the configuration
flash memory (CFM) which provides non-volatile storage for the bit stream. The information is
retained within CFM even if the DE10-Lite board is turned off. When the board is powered on, the
configuration data in the CFM is automatically loaded into the MAX 10 FPGA.
◼
JTAG Chain on DE10-Lite Board
The FPGA device can be configured through JTAG interface on DE10-Lite board, but the JTAG
chain must form a closed loop, which allows Quartus II programmer to the detect FPGA device.
Figure 3-1
illustrates the JTAG chain on DE10-Lite board
Figure 3-1 The JTAG configuration scheme
