Marquee™ Point-to-MultiPoint Series User Guide
6. Click
the
Setup
tab and and then the
Interface Setup
button: all interfaces will say
Not Configured
.
Highlight
Interface 1
and in the drop down menu to the right select
Ethernet
. Highlight
Interface 2
and in the dropdown menu to the right select
IEEE 802.11
. At this point,
Interface 1
must say
Ethernet
and
Interface 2
must say
IEEE 802.11
. Click
OK
.
7. Click
the
File
menu and select
Upload Software
. You should get a window asking for an IP address,
and password. Enter the IP Address of the unit to be upgraded (if you want, click the
Scan
button to
verify you can see it). Enter the password for the unit and click
OK
.
8. You should get several warning windows. Simply click
Yes
to these. When the saving is finished the
unit should reboot. If you get a confirmation window, just click
OK
.
9. After the unit has rebooted, click the
File
menu and select
Open Remote Config
. Click the
Scan
button: the unit should now show up with an IP address of 198.17.74.253 or 254. This is the default IP
address. At this point, you can change your computer's IP to match it, (for example, change your
computer’s IP to 198.17.74.250, subnet mask 255.255.255.0), or highlight the unit on the scan
windows and click the
Change IP
button.
NOTE:
if the Change IP option is used your computer must
have an IP assigned within the same IP subnet as the one you are changing the device to.
10. Once this is done, click
OK
on both windows and you should get a message stating that the
configuration has been read. Click
OK.
Now you can configure the device with the options in the
Setup
menu.
After all of this, if a connection can still not be established:
1. Make sure you have clear line of site.
2. Make sure your antennas are properly aligned. With their narrow beamwidth, it may take a bit of
time. Only align one side at a time, using an extremely slow side to side and up to down motion.
3. Try setting the transmit rate to the lowest setting (6 Mbps).
4.4
When to Contact Technical Support
If at this point you continue to have problems and you have verified all cable connections for security or
damage, confirmed Line of Site, checked multipath, interference and antenna alignment, and made sure
you have a functional and working configuration, then there are no further troubleshooting steps that can
be taken. You are either out of range or there is an actual equipment failure. Contact technical support for
further assistance:
•
Customer Support on the
East Coast
– please call
1-888-297-9090
(overseas customers please call
+1-703-205-0600
or email
)
•
Customer Support on the
West Coast
– please call
1-800-664-7060
(overseas customers please call
+1-408-617-8150
or email
)
Version 1.3(a)
Page 23
Jul 2005
