Marquee™ Point-to-MultiPoint Series User Guide
discarding pole clamp (C) and replacing it with metal straps (not included) fastened through slots
located on the pole mounting bracket (B).
Figure 2.8 – Detail Showing Assembly of Pole Mounting Bracket to Marquee P-MP EX
B
A
Serrated Edges
Figure 2.9 – Attaching the Marquee P-MP EX Unit to the Pole
Slots for optional
metal straps
C
Max 3.0”
Min 1.0”
Proceed to Section 2.7 – Cabling the Marquee P-MP (All Enclosures).
2.7
Cabling the Marquee P-MP (All Enclosures)
1. Ensuring that there is no DC power applied to the cable, plug the 6-pin N-male round connector of the
outdoor Ethernet cable (ordered separately) into the rear jack of the unit, making sure the notch on
the connector is correctly aligned with the tab on the jack as shown on Figure 2.10. Turn the round
locking nut clockwise as you push in until it securely fastens onto the jack.
Please verify that the
round connector is properly plugged into the rear jack of the antenna prior to connecting DC
power
because it is possible to push it in the wrong way if enough force is used. If DC power is
applied and the connector is not properly plugged, damage to the electronics of the unit or the
connector itself may occur which will not be covered by the factory warranty.
Version 1.3(a)
Page 8
Jul 2005
