Tense RGT-MT18, User Manual

Page: 25 / 36

How is the S tep Value Entered Manually?
How i s The Step Test Done?
21
In order to reach ''Enter Step Value'' page, enter these
menus subsequently;
After reaching the Enter Step Value page; Step, Phase, and
Values are set pressing ''up'' and ''down'' buttons. Then the
values are recorded pressing the ''Confirm'' button and
'' 1. Step L1 Value was Saved! '' sign comes to the screen.
In order to reach the step test page ,enter these menus
subsequently;
All of the steps will be apparent on the screen; after
reaching Step Test Page. Touching the step; it is pulled and
left back. If the logo of the step is ''red x'' ; when Quit the
Step button is pressed, logo of the step becomes
green thick and gives Quit. When we press the same step
button again, the logo changes and the steps don't give quit.
SETTINGS
Select the Steps to Test!
1
14 13 12
7 6 5
18
11
4
17
10
3
16
9
2
8
15 TCR
TURN BACK
Capacitor
Shunt Reactor
Ex: C apacitor value is entered to the 1st step at the L1 phase
If the value to be entered is mono phase, from the phases section ''L1,L2 or L3''should be
chosen according to the phase which is connected to; if it is three phase ''L123'' should be
chosen.
OK
Enter the Step Value!
Step
01
Phase
L1
Value (kVar)
-1.00
TURN BACK
OK
Enter the Step Value!
Step
02
Phase
L123
Value (kVar)
-10.00
TURN BACK OK
Enter the Step Value!
Step
03
Phase
L3
Value (kVar)
+1.50
TURN BACK
3 phase 10kVar capacitor value
entered to the 2nd step.
1.5kVar shunt reactor value
entered to the 3rd step at the L3 phase.
If ''the Return'' button is pressed; step main page comes to the screen by abandoning
steps one by one.
Settings E
Settings E
Step Settings E
Step Settings E
Enter the Steps Value E
Step Test E
1. Step L1 Value was Saved!
Note:
If the condenser will be added to the system, the value to be entered should be
''-'' (picture6); if the shunt reactor is to be added ,the value to be entered should be
''+'' (picture7).