Tense RGT-MT18, User Manual

Page: 14 / 36

To set the current transformer value, press the up and
down arrow buttons on the screen after pressing the
"Change current transformer value" button. The test starts
automatically when the "Confirm" button is pressed. If there
are any problems in the connection, the device will give a
warning and will not accept the connection.
Enter the CT Ratio
0150
/5A
OK TURN BACK
The test starts automatically when the "Start current
transformer test" button is pressed. If there are any
problems in the connection, the device will give a warning
and will not accept the connection.
If the current transformer test is successful and the
connection is confirmed, the device starts to measure the
step automatically.
Cancel
CT Test
Confirm
CT Connection
Current
380.0
380.0
380.0
CT Test was Started
Current Transformer Test
L1
L2
L3 A
A
A
3.1.1 Current Transformer Test
3.1.2 Changing the Current Transformer Value
If the current transformer test is successful and the connection is confirmed, the device
starts to measure the step automatically.
OK
THDV Protection Settings
Delay (sn.) THDV Set (%)
20 40
TURN BACK
THDV Control Mode Active
3.2 Voltage Harmonic Protection
In this page you can start the current transformer test and
change the current transformer value.
On this page, when the "Start Current Transformer Test"
button is pressed, the current transformer test is started.
When the "Change Current Transformer Value" button is
pressed, the current transformer value changing page is
displayed on the screen.
ÖLÇÜMLER
L1 - Harmonik Distorsiyon Gerilim
3.
5.
7.
9.
11.
13.
0.0 0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0 0.0
15.
17.
19.
21.
23.
25. 27.
29.
31.
33.
35.
37. 39.
41.
43.
45.
47.
49. 51.
53.
55.
57.
59.
61.
ILERI GERI
Start
CT Test
Back
Settings Page
Current Transformer Settings
TEST
K k
L l
Change Current
Transformer Ratio
X 5A
When the "Back" button is pressed, the "Settings" page appears on the screen.
10
3.1 Current Transformer Settings
In this page voltage harmonic control mode can be made
active or passive, harmonic of total voltage and delay of it can
be set. When the set is active the colour of the button's
writing becomes green, and when the set is passive it
becomes red. When the control mode is active and the total
voltage harmonics get higher than the setted harmonic
values, the device waits as much as delay; after the time of
the delay comes to an end it makes the compensation stop
and ''High Harmonic Voltage'' warning comes to the screen. Also ''ALR1''is on. When the
control mode is passive, the device doesn't make voltage harmonic control. Pressing the
''Confirm'' button, the saved data is recorded and returns to ''Settings'' page.
When the ''Return'' button is pressed, without recording any value, turns to ''Settings'' page.
Settings E
Settings
E
Current Transformer
E
Settings
E
Current Transformer
E Settings E