Tense RGT-MT18, User Manual

Page: 17 / 36

3.9 Modbus S ettings
In this page remote communication settings can be done to
the device. Addresses of Baudrate and Modbus can be
changed. Databits=8, Stopbits=1 and Parity=none values are
fixed.
Pressing the ''Confirm'' button, the saved data is recorded
and returns to ''Settings'' page. When the ''Return'' button is
pressed, without recording any value, turns to ''Settings''
page.
OK
ModBus Settings - 8 N 1
Baudrate Modbus Address
19200
001
TURN BACK
In this page, the intervention time, the capacitor discharge
time and the capacitor settling time can be set.
Drive time:
it is the İntervention (Step taking-drop) time of the
device to the power change in the system.
Discharge time: It is the delay time of re-commissioning the
same step after dropping the capacitor in the step.
Step settling time: When a few steps are needed is the delay time between steps.
3.10.1 Step Times
OK
Step Time Settings
Drive
Time (sn)
Discharge
Time (sn)
Settling
Time (msn)
04 15 0400
TURN BACK
13
3.10 Step Settings Page
3.10.1 Times : Drive , D ischarge and Settl ing Times are set.
3.10.2 Enter Step Value : Value of step is entered manually
3.10.3 Automatical Measurement :
The selected steps are measured.
Back Settings Page : Returns to the Settings page.
3.10.4 PFC Settings :
Compensation can be active or passive mode.
3.10.5 Stage Test : The selected steps are checked.
Step Settings
Back
Settings Page
Time Settings
PFC Settings
Enter
the Steps Value
Step Test
TEST
Auto Measurement
n
When the Stage Button is pressed, Stage
Settings page comes to the screen in the
dynamic area. Times related to steps, Enter
Stage Value, Automatical Measurement, PFC
Settings, Stage Test and Settings Page can be
passed from this page.
Pressing the ''Confirm'' button, the saved data is recorded and returns to ''Settings'' page.
When the ''Return'' button is pressed, without recording any value, turns to ''Settings'' page .
Settings E
Settings E
Settings E Step Settings E