OPERATION
26
Tennant T300e/T300 (02- 2016)
6. Drive models - push the directional lever to the
forward position to go forward (Figure 73). To
reverse the machine pull the directional lever
backwards.
FIG. 73
7. To begin scrubbing, pull the start bail (Figure 74).
FIG. 74
8. Drive models - Adjust the scrubbing speed by
turning the speed dial to the desired speed
(Figure 75).
Push models - Slowly push the machine forward.
The rotating brush(es) will help assist the machine
forward.
FIG. 75
9. T300e ec-H2O model - To adjust the solution flow
rate when ec-H2O scrubbing, press the solution
flow button located on the ec-H2O module (Figure
76). One LED= low, two LED’s=medium, and three
LED’s= high.
FIG. 76
10. T300e model - To adjust the solution flow rate
when conventional scrubbing, turn the solution flow
control knob located underneath machine (Figure
77).
NOTE: The solution flow control knob is only functional
when conventional scrubbing.
FIG. 77
11. T300e model option / T300 manual down pressure
model - When extra brush pressure is needed for
heavily soiled areas lift the down pressure lever
(Figure 78).
NOTE: Release the down pressure lever when raising
scrub head.
FIG. 78
12. To stop scrubbing, release the start bail and raise
the scrub head and squeegee assembly off floor.
Turn key off and set parking brake, if equipped.
