Tennant 5300T, Service Manual

Page: 36 / 98

SCRUBBING
5300T MM382 (10–94)
3Ć14
SCRUB BRUSH DOWN PRESSURE GROUP
TO REPLACE BRUSH PRESSURE TEE
HANDLE
1. Turn the machine power off and set the
parking brake if your machine has this
option.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, Turn Off
Machine.
2. Remove the four phillips head mounting
screws that hold the bracket in place.
3. Remove the screw going through the slot in
the bracket that is threaded into the down
pressure coupler. Un–thread the tee knob
from the coupler.
4. Drive the pin out of the collar using a 1/8
inch drift pin.
5. Remove the collar from the tee knob,
remove the tee knob from the bracket.
6. Install the replacement tee knob into the
bracket. Install the collar and pin.
7. Thread the tee knob into the down pressure
coupler and reassemble the remaining parts,
reversing the procedures in steps 1 and 2.
09480