Tennant 1465, Operator'S Manual

Page: 66 / 70

MAINTENANCE
1465/1480/1490 MM185 (9–90)
3Ć26
DEBRIS HOPPER SLIT SKIRT
The debris hopper slit skirt helps direct debris into
the hopper. It is located at the bottom rear of the
debris hopper. The rear lip of the slit should
always lie flat and contact the floor. Check the
skirt every 25 hours of operation for damage or
wear.
PRE-SWEEP HOPPER SEALS
There are several seals to seal the debris hopper.
One seal is located on the Pre-Sweep
frame
where the debris hopper comes in contact with
the frame. There is also two seals located on the
both sides of the debris hopper. Check these
seals every 25 hours of operation for damage or
wear.
A
B
B
04399
PRE-SWEEP HOPPER SKIRTS AND SEALS
A. Hopper Slit Skirt
B. Hopper Seal