MAINTENANCE
3Ć11
1465/1480/1490 MM185 (9–91)
SCRUB HEAD
SCRUB HEAD
The scrub head houses the two scrub brushes,
and their drive and lift mechanisms. The scrub
head has one adjustment – scrub head leveling. It
is factory adjusted and should not be changed
unless scrub head parts are damaged or are
replaced. If the scrub head is not level, the
brushes will apply uneven pressure and may
bounce. It also would cause excessive wear on
the brush drive plugs and bearings.
TO LEVEL SCRUB HEAD
1. Stop the machine on a smooth, level floor.
2. Lower the scrub brushes.
3. Turn the machine off and set the machine
parking brake, if equipped.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, Set Parking
Brake (If Equipped), And Turn Off Machine
And Remove Key.
4. Remove the scrub head cover by pressing
on the release levers on both sides of the
scrub head cover and pulling forward.
B
A
04366
SCRUB HEAD COVER RELEASE
A. Scrub Head Cover
B. Release Lever
5. Position a level on the scrub head from front
to rear.
6. Adjust the support link ball joints so the head
is level front to rear. Tighten the ball joint
jam nuts after making adjustments.
A
B
04368
LEVELING SCRUB HEAD
A. Scrub Head
B. Support Link
7. Start the machine.
8. Raise the scrub brushes.
9. Lower and start the scrub brushes.
10. Turn machine off.
11. Recheck the front to back level of the scrub
head. Readjust if necessary.
12. Replace the scrub head cover.
Summary of Contents for 1465
