OPERATION
1465/1480/1490 MM185 (9--90)
2-8
SQUEEGEE SWITCH
The squeegee switch
, along with the
steering handles, control the position of the rear
squeegee and the vacuum fan.
To start the vacuum fan and lower the rear
squeegee, press the squeegee switch. When the
steering handles are twisted backward, the
squeegee lifts. This prevents the rear squeegee
from being damaged when backing machine. The
squeegee will lower when the steering handles
are twisted forward again.
To stop the vacuum fan and raise the rear
squeegee, press the squeegee switch again.
BRUSH PRESSURE SWITCH AND INDICATOR
The brush pressure switch
controls how
aggressive the brushes are on the floor. The
brush pressure indicator shows the pressure
selection.
The brush pressure switch has four positions.
Under normal conditions, the brush pressure
should be set in the light zone. Under heavy grime
conditions, the brush pressure should be set in
the heavy zones. Travel speed and floor
conditions will affect the scrubbing performance.
A
B
C
D
04361
BRUSH PRESSURE SWITCH AND INDICATOR
A. Brush Pressure Switch
B. Brush Pressure Indicator
C. Light Pressure Zone
D. Heavy Pressure Zone
To change brush pressure, touch the brush
pressure switch. Each time you touch the switch it
will increase brush pressure until it reaches the
maximum setting. Then it will return to the
minimum setting as shown on the pressure
indicator.
SUPER SCRUB SWITCH
The super scrub switch allows spot cleaning of
heavy grime buildup by putting the brush pressure
into the heavy setting for approximately 30
seconds when activated. After the 30 seconds,
the brush pressure will revert back to the previous
setting.
SCRUB BRUSH SWITCH
The scrub brush switch
controls scrub brush
position and rotation.
To lower and start the brushes turning, press the
scrub brush switch. To raise and stop the
brushes, press the scrub brush switch again.
NOTE: On the 1490 machines, the propelling
control must be activated to lower and start the
brushes. When the machine is stopped, the
brushes will automatically stop and raise.
SOLUTION LEVER
The solution lever
controls the flow of
solution to the floor.
To start solution flow, move the solution lever up
slightly. To increase to full flow, move the lever all
the way up.
To stop solution flow, move the lever all of the way
down.
A
04359
SOLUTION LEVER
A. Solution Lever
Summary of Contents for 1465
