Snappi System User Manual
Document No: 053-05 v19
Page 33 of 66
March 2013
Snappi System User Manual.doc
(On Snappi Pushchairs with 3 side cam
buckles) Thread the bottom straps through
the gap at each side between the back
upholstery and hip guides and down through
the cam buckles at the rear of the side plate.
Set at the desired length and close cam
buckle to secure webbing (Fig 5.6.7)
OR
Fig 5.6.7
(On Snappi Pushchairs with 1 side cam
buckle) Thread the bottom straps through the
gap at each side between the back
upholstery and hip guides. Twist the cam
catch to one side so you can access the top
of the bolt where you will need to attach the
harness bottom strap (Fig 5.6.8).
Fig 5.6.8
Fig 5.6.9
Using a 6mm Allen Key and a 10m spanner
undo the nut (nearest to the base of the seat)
and remove the nut and washer. Place the
folded end of the bottom harness strap
through the bolt using the pre-drilled hole.
Ensure the strap is flat then replace washer
and nut, retighten the nut. (Fig 5.6.9)
Top of bolt
Twisted cam buckle
