Snappi System User Manual
Document No: 053-05 v19
Page 51 of 66
March 2013
Snappi System User Manual.doc
Fig 6.8.4
To fit the play tray to the seat,
locate the 2 vertical stems on the
bottom of the tray into the 2
receivers on the seat unit. Note
there may be a small plastic cap in
the top of the receiver. If this is the
case, remove the cap using a small
flat bladed screwdriver before fitting
the playtray.
Screw the 2 thumbwheels supplied
with the tray into the welded nut on
the receivers as shown (see Fig
6.8.4). Position the tray to the
required height, and then secure it
in
place
by
tightening
the
thumbscrews.
To adjust the angle of the playtray, loosen the 2
angle adjustors (see Fig 6.8.5).
Once loose, adjust the angle as required and
retighten.
N.B. the angle adjustors are toothed, and may
require some force to move. The angle adjustors
move in 5-degree increments.
Fig 6.8.5
Fig 6.8.6
To adjust the depth of the playtray,
loosen the 2 thumbscrews under
the base of the tray (See Fig 6.8.6).
Slide the tray in or out to the
required depth, and then retighten
the screws.
