Snappi System User Manual
Document No: 053-05 v19
Page 20 of 66
March 2013
Snappi System User Manual.doc
5.1 Adjusting the seat unit
Common adjustments on the Snappi Seat can be made by hand (such as back height and
back recline angle) and require no tools. Less frequent adjustments are made using a
5mm hexagon key (supplied), such as the seat depth and width. No other tools are
required to make adjustments to the seat.
5.1.1 Seat Depth and Hip Guides
Fig 5.1.1.1
To adjust the seat depth and width, first
remove the seat base cover (this is attached
by Velcro in the centre of the seat and is
easily removed by pulling it away from the
frame).
Using the supplied 5mm hexagon key,
loosen the 4 seat fixings.
Next set the seat width (‘A’ see Fig 5.1.1.1)
as measured in section 5.0 by sliding the
hip guide brackets in or out as required.
To adjust the seat depth (‘B’ see Fig
5.1.1.1), slide the upper of the base plates
forward or back to achieve the required
position.
Once adjusted, tighten the 4 bolts using the
hexagon key and fit the cover back into
place.
The Snappi hip guide also offers depth
adjustment (‘C’ see Fig 5.1.1.2) to best suit
your child’s needs.
To adjust this, remove the hip guide cover.
This is done by unclipping the two “poppers”
and lifting the cover off the plastic plate.
Next, use the 5mm hexagon key to loosen
the 2 fixings, and slide the plate into the
desired position as shown (see Fig 5.1.1.2).
Once adjusted, tighten the 2 fixings and refit
the hip guide cover.
Fig 5.1.1.2
