TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03)
Page 17
Name
Command
ASCII
Command
+n
= data
byte[hex]
Description
Select
paper
type
ESC c 1
+n
[1B 63 31
+n
]
See Section 4.2.7.4 - Select Paper
Type.
Set
printing
speed
ESC s
+n
[1B 73
+n
]
Print if needed then set the printing
speed. 60hex = High speed..
61hex or 62hex = medium speed
(The print time is longer so the
print is a little darker). 63hex = low
speed printing (the peak current
required is about half of what is
needed for the other speeds).
Print
Pulse
width
FS E
+n
[1C 45
+n
]
Set the PRINT PULSE time.
Default = 57. Range = 0 to 255
dec. Larger values of n cause
darker print, smaller values of n
cause lighter print. THE LIFE OF
THE PRINT HEAD IS
SHORTENED WHEN THE PULSE
WIDTH IS INCREASED. NEVER
exceed a value of n=128dec.
Set Print
quality
GS E + n
[1D 45
+n
]
Sets the printing quality
conforming to the paper used. The
low order 4 bits change the print
darkness with x0hex being the
lightest and xFhex being the
darkest. The default is 3.
Table 9 - Seldom Used Commands
4.2.6
Commands Not Covered In This Manual
Several commands require additional memory chips to be present on the
controller board and are not covered in this manual. These commands pertain
to printing KANJI characters, allowing for storing and printing download
character sets, download of bit image patterns, etc.
Summary of Contents for MTP-600 Series
Page 6: ......