TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03)
Page 14
Name
Command
ASCII
Command
+n
= data
byte[hex]
Description
Set Left
Margin
GS L
+
n1
+
n2
[1D 46 +
n1
+
n2
]
Print if needed and then sets the
left margin to dot position
n2
x
256+
n1
. In text mode, the
margin is set module 4,
n1
= 0
through 3 gives a left margin of
0,
n1
= 4 through 7 gives a left
margin of 4 dots, etc. In bit
image mode, the margin is set
modulo 8. The minimum
allowable distance from the right
margin is 80 dots. Bar Code
commands are ignored if left
margin and right margins are set
too close for the barcode to be
printed.
Paper cut
GS V
+n
+m
[1D 56
+n
+m
]
If
n
= 0 (either 00hex or 30hex) a
full cut is performed and the
+m
byte must not be sent. If
n
= 1
(either 01hex or 31hex) a partial
cut is performed and the
+m
byte must not be sent. If n is a
capital A (41hex) then paper is
fed for m dot lines and then a full
cut is performed. If n is a capital
B (42hex) then paper is fed for
m dot lines and then a partial cut
is performed.
Set Right
Margin
GS W +
n1
+
n2
[10 57 +
n1
+
n2
]
Same rules as GS L +
n
Set Left
Margin listed above.
Table 5 - General Usage Print Commands
4.2.2
Status Commands
Status Commands
Name
Comman
d
ASCII
Command
+n
= data
byte[hex]
Description
Set Error
Detection
parameters
FS 9
+n
[1C 39
+n
]
Sets the detection functions. See
Section 4.2.7.5 - Status
Commands for warning.
Set value of
Status byte
number 4 to n
FS r
+n
[1C 72
+n
]
Set value of STATUS byte
number 4 to n. See Section
4.2.7.5 - Status Commands.
Set /Reset
Auto status
notification
GS a
+n
[1D 61
+n
]
Notify the printer status. See
Section 4.2.7.5 - Status
Commands.
Table 6 - Status Commands
Summary of Contents for MTP-600 Series
Page 6: ......
