Telpar MTP-600 Series, User Manual

Page: 17 / 45

TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03) Page 11
4.1.1.2 DSW2 – DIP Switch 2
DIP Switch 2 (DSW2) Settings
Setup Status Item Bit
No.
Bit 1 Bit 2
Setup State Setup
before
shipping
OFF OFF MTP-620
OFF ON MTP-630
Printer
mechanism
setting 1, 2
ON OFF MTP-640
As
required
for mech
OFF Memory not
installed Registration
memory
installation 3
ON Memory
Installed
OFF -
Not
installed
OFF No paper
cutting at
test printing Paper cutting
selection 4
ON Paper
cutting at
test printing
ON -
Paper
cutting
Table 4 - DIP Switch 2 (DSW2) Settings
4.2 Control Codes and Control Sequences
4.2.1 General Usage Print Commands
General Usage Print Commands
Name Command
ASCII
Command
+n
= data
byte[hex]
Description
Tab HT [09] Move the print position to the next
horizontal tab position. Default is a
TAB position every 8 columns. See
ESC D.
Line feed LF [0A] Print data and feed paper. Default
line spacing = 1/8 inch.
Form feed FF [0C] Print if needed then feed paper to
the top of the next page. Default
page length is 44 lines. See ESC C.
When CUT SHEET is selected as
the paper type and the page length is
set to 0 (See ESC C) then the paper
is ejected until paper is not seen by
the paper out sensor.
When LABELS is selected as the
paper type, data in the print buffer is
printed and paper is advanced to the
next label using the MARK detector.