TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03)
Page 8
3 Installation
3.1 Self Test Mode
The MTP-600 has a self-test mode that will print and cut a sample ticket.
To place the unit into self-test mode, first turn power switch off, then press and hold the
FEED push button switch and place the POWER switch in the ON position.. Release the
switch after printing starts. Self-test samples will be printed and cut continuously until
power is cut off Figure 7 MTP-630 Self Test Printout and (
Figure 8 - MTP-620 Self Test
.)
All electrical/mechanical portions of the printer are exercised and checked by this action,
except for the serial interface or parallel interface components.
The self-test printout is similar for both the serial and parallel interfaces. If the DIP
switches that select the printer mechanism are set correctly, the first character on the line
following the
checker board
pattern will be a “2”, “3” or “4” indicating a 2-inch, 3-inch or 4-
inch printer mechanism is connected to the controller board.
Summary of Contents for MTP-600 Series
Page 6: ......
