TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03)
Page 15
4.2.3
Bar Code Commands
Bar Code Commands
Name
Command
ASCII
Command
+n
= data
byte[hex]
Description
Set Bar
width
GS e
+n
m
[1D 65
+n +m
]
Set width of the bars used
for bar code printing. n=
width of a narrow bar. m =
width of a wide bar. Defaults
are
n
= 2 and
m
= 6. Range
= 1 to 255dec. If a bar code
does not consist of wide bars
and narrow bars, n is set to
the minimum width.
Set Bar
code
height
GS h
+n
[1D 68
+n
]
Set the bar code height in
dots. Default = 60. Range - 1
to 255dec.
Bar code
printing
GS k
+m
+n
+d1
∼
dn
[1D 6B
+m +n
(DATA)]
Selects the bar code type
and prints. See Section
4.2.7.7 - Bar Code
Command.
Set Bar
code
width
magnifica
tion
GS w
+n
[1D 77
+n
]
Set the bar code width. Both
the narrow bar width and the
wide bar width are multiplied
by n. Default = 1. Range = 1
to 255dec.
Table 7 - Bar Code Commands
4.2.4
Top of Form Commands
Top of Form Commands
Name
Command
ASCII
Command
+n
= data
byte[hex]
Description
Mark
detection
(
See
note
below)
GS
<
[1D 3C]
Line feed to the next mark.
Set Line
feed
length
after
mark
detection
GS A
+m
+n
[1D 41
+m
+n
]
Sets the line feed length after
mark detection. m = 0. n = head
detection distance in dot lines.
Range = 0 to 63. Default = 16.
Table 8 Top of Form Commands
Minimum Form Length
The firmware included on the controller board will cause a TopOfForm error if
the printer receives a SeekTopOfForm command (GS <) but a TopOfForm
Summary of Contents for MTP-600 Series
Page 6: ......