TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03)
Page 13
Name
Command
ASCII
Command
+n
= data
byte[hex]
Description
Forward
paper feed
for
n
dot
lines
ESC J
+n
[1B 4A
+n
]
Print if needed then feed paper n
dot lines. Range = 0 to 255dec.
Reverse
paper feed
for n dot
lines
ESC K
+n
[1B 4B
+n
]
Print if needed then reverse feed
paper n dot lines. Range = 0 to
255dec.
Select
International
character
set
ESC R
+n
[1B 52
+n
]
Select international character
set.
See Section 5.6 - International
Character Set
Rotate print
ESC V
+n
[1B 56
+n
]
n
= 1 = Rotate the print 90
degrees clockwise.
n
= 0 =
Cancel the rotation. Inverted
print can also be in effect to
cause 270 degrees rotation. This
is NOT a PAGE MODE. Does
NOT apply to bar codes, Bit
image, or registered image
printing. Normal print and rotated
print can occur on the same line.
Double wide becomes double
high and double high becomes
double wide. Requires careful
formatting.
Forward line
feed for n
character
lines
ESC d
+n
[1B 64
+n
]
Print if needed then feed paper n
character lines. Range = 0 to
255dec.
Reverse line
feed for n
character
lines
ESC e
+n
[1B 65
+n
]
Print if needed then reverse feed
paper n character lines. Range =
0 to 255dec.
Select
Character
code table
ESC t
+n
[1B 74
+n
]
Bit 0 of n=0 => Japan. Bit 0 of
n=1 => Overseas (Code page
437). Default is 0.
Set/Reset
Inverted
print
ESC
{
+n
[1B 7B
+n
]
Bit 0 of n=1 => upside-down
printing. Bit 0 of
n
=0 => normal
printing. This command must be
received at the start of a line to
be in effect for that line.
Summary of Contents for MTP-600 Series
Page 6: ......
