TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03)
Page 5
2 Operator Instructions
2.1 Unpacking and Inspection
Carefully unpack and inspect your MTP-600 for any damage that may have occurred in
transit. Should any damage have occurred, notify TELPAR, save the shipping carton and
packing materials, and file a damage claim with the carrier. Specify the nature and the
extent of the damage. Before installing or operating the printer, check the following:
•
Printer mechanism and paper path are clear of all packing materials or
other foreign matter.
•
Paper is installed. DO NOT OPERATE the printer without paper. Refer to
Section 2.2 - Paper Loading for paper loading instructions.
2.2 Paper Loading
2.2.1
Side-Loading Roll
The MTP-600 series printer may be configured as a side-loading printer. Slide
roll of paper over spindle with paper fed over the top toward paper slot (front of
unit).
To load paper, turn on the power and feed the straight edge of the paper into
the paper guide. Once paper has been initially loaded, the paper feed button
may be used. Ensure that the paper is installed correctly and feeding properly
with the thermal side facing up.
If AUTOLOAD has been enabled by the ESC C 1 3 command, inserting paper
will result in the automatic loading of paper once it is fed into the paper guide.
See ESC EM
+n
command for amount of paper to be automatically fed.
2.2.2
Drop In Roll
The MTP-600 series printer may also be configured as a drop in loader. Load
the roll of paper by placing the spindle inside the roll of paper and place spindle
in slots with paper fed over the top toward the paper slot (front of unit).
To load paper, turn on the power and feed the straight edge of the paper into
the paper guide. Once paper has been initially loaded, the paper feed button
may be used. Ensure that the paper is installed correctly and feeding properly
with the thermal side facing up.
If AUTOLOAD has been enabled by the ESC C 1 3 command, inserting paper
will result in the automatic loading of paper once it is fed into the paper guide.
See ESC EM
+n
command for amount of paper to be automatically fed.
2.2.3
Fan Fold Load
Alternately, the MTP-600 series printer may be configured as a printer for fan-
fold forms. This requires the use of a pre-printed Top of Form (TOF) Mark or
Black Mark on the form
Summary of Contents for MTP-600 Series
Page 6: ......
