Viewing and Modifying Boot Parameters
B-3
PN 76.8820IM30-A
Tellabs 8820 Multi-service Switch Router System Installation
Step 4
If necessary, use the cf command to modify boot parameters. To enter the change,
type the new setting alongside the current setting, as shown in the Client IP
address field in the following example.
M>
cf
Client IP address ............................ : [10.8.4.63]
10.8.4.64
WARNING: These settings should ONLY be changed if there
is no currently active switch card and this card
will become the active. Otherwise the settings
will be overwritten by the active switch card's
settings. Would you like to proceed and change
the IP address to 10.8.4.64 ? [y/n] n
Network IP mask .............................. : [255.255.0.0]
Gateway IP address ........................... : [10.8.0.1]
TFTP server IP address ....................... : [10.6.25.29]
Boot directory ............................... : [./]
Boot file when using TFTP .................... : [viva_strip.elf]
Shelf number ................................. : [0]
Enable Ethernet auto-negotiation ............. : [Yes]
Ethernet port rate (10/100 Mbps)
Only used if auto-negotiation is disabled .. : [100]
Ethernet duplex (half/full)
Only used if auto-negotiation is disabled .. : [Full]
Client IP address ............................ : [10.8.4.63]
Network IP mask .............................. : [255.255.0.0]
Gateway IP address ........................... : [10.8.0.1]
TFTP server IP address ....................... : [10.6.25.29]
Boot directory ............................... : [./] .
M>dc
Client IP address ............................ : 10.8.4.63
Network IP mask .............................. : 255.255.0.0
Gateway IP address ........................... : 10.8.0.1
TFTP server IP address ....................... : 10.6.25.29
Boot directory ............................... : ./
Boot file when using TFTP .................... : viva_strip.elf
Shelf number ................................. : 0
Enable Ethernet auto-negotiation ............. : Yes
Ethernet port rate (10/100 Mbps)
Only used if auto-negotiation is disabled .. : 100
Ethernet duplex (half/full)
Only used if auto-negotiation is disabled .. : Full
M>
Node address
Boot directory location at the TFTP server.
Do not change
Gateway used by the management
Ethernet interface for connection to any
external
non-directly connected
management device.
Autonegotiation mode setting, as either on
(enabled) or off (disabled)
Ethernet port rate setting in Mbps, as either
10 or 100.
Ethernet duplex mode setting, as either full
or half.
