HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 62 of 229
+CCFC - Call Forwarding Number And Condition
AT+CCFC=?
Test command reports supported values for the parameter
<reason>
.
Reference
3GPP TS 27.007
Note
When querying the status of a network service
(<cmd>=2
) the response line for 'not
active' case
(<status>=0
) should be returned only if service is not active for any
<class>
.
3.5.3.3.11.
Call Waiting - +CCWA
+CCWA - Call Waiting
AT+CCWA=
[<n>[,<cmd>
[,<class>]]]
Set command allows the control of the call waiting supplementary service.
Activation, deactivation, and status query are supported.
Parameters:
<n>
- enables/disables the presentation of an unsolicited result code:
0 - disable
1 - enable
<cmd>
- enables/disables or queries the service at network level:
0 - disable
1 - enable
2 - query status
<class>
- is a sum of integers each representing a class of information which the
command refers to; default is 7 (
voice + data + fax
)
1 - voice (telephony)
2 - data
4 - fax (facsimile services)
8 - short message service
16 - data circuit sync
32 - data circuit async
64 - dedicated packet access
128 - dedicated PAD access
Note: the response to the query command is in the format:
+CCWA: <status>,<class1>[<CR><LF>
+CCWA: <status>,<class2>[ … ]]
where
<status>
represents the status of the service:
0 - inactive
1 - active
<classn>
- same as
<class>
Note: the unsolicited result code enabled by parameter
<n>
is in the format::
+CCWA: <number>,<type>,<class>,[<alpha>][,<cli_validity>]
where:
<number>
- string type phone number of calling address in format specified by
<type>