HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 160 of
229
3 - antenna not detected (open).
<urcmode>
- URC presentation mode. It has meaning only if
<mod>
is 1.
0 - it disables the presentation of the antenna detection URC
1 - it enables the presentation of the antenna detection URC, whenever the antenna
detection algorithm detects a change in the antenna status; the unsolicited
message is in the format:
#GSMAD: <presence>
where:
<presence>
is as before
<interval>
- duration in seconds of the interval between two consecutive antenna
detection algorithm runs (default is 120). It has meaning only if
<mod>
is 1.
1..3600 - seconds
<detGPIO>
- defines which GPIO shall be used as input by the Antenna Detection
algorithm (default 13)..
Valid range
is “any input pin number” (see “Hardware User Guide”).
<repGPIO>
- defines which GPIO shall be used by the Antenna Detection
algorithm to report antenna condition. Value 0 means that no report is
made using GPIO (default 0). It has meaning only if
<mod>
is 1.
0 - no report is made using GPIO
Valid range
is “any output pin number” (see “Hardware User Guide”).
Note: last
<urcmode>
settings are saved as extended profile parameters.
Note: GPIO is set to LOW when antenna is connected. Set to HIGH otherwise
Note:
#GSMAD
parameters, excluding
<urcmode>
, are saved in NVM.
AT#GSMAD=?
Test command reports the supported range of values for parameters
<mod>,
<urcmode>, <interval>, <detGPIO>
and
<repGPIO>
.
AT#GSMAD?
Read command returns the current parameter settings for
#GSMAD
command in
the format:
#GSMAD: <mod>,<urcmode>,<interval>,<detGPIO>,<repGPIO>
3.5.5.1.45.
V24 Output Pins Configuration - #V24CFG
#V24CFG - V24 Output Pins Configuration
AT#V24CFG=<pin>,
<mode>
Set command sets the AT commands serial port (
UART
) interface output pins
mode.
Parameters:
<pin>
- AT commands serial port interface hardware pin: