HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 164 of
229
#REGSTAT - Current Network Registration Status
where:
<State>
0 - not registered
1 - registered, GPRS attached
2 - registered, EDGE attached
3 - registered, WCDMA attached
4 - registered, HSDPA attached // with DFS22.21.00, DFSD23.09.01
5 - registered, HSUPA attached // with DFS22.21.00, DFSD23.09.01
6 - registered, HSUPA and HSDPA attached
AT#REGSTAT?
Read command reports the current values of <n> and <State>
#REGSTAT: <n>,<State>
where:
<n>
- see before
<State>
- see before
AT#REGSTAT =?
Test command returns all supported values of the parameters.
3.5.5.1.51.
Set Reporting Call Status - #CALLSTAT
#CALLSTAT - Set Reporting Call Status
AT#CALLSTAT=<en
able>
Set command is used to enable/disable the CALLSTAT.
This command allows enabling / disabling the reporting voice call status on DTE
using an unsolicited result code #CALLSTAT: <call_id><stat>. This code may be
repeated so that for each call one line is displayed on DTE
(e.g. one call is active and one call is waiting, or up to 6 calls are active in a
multiparty session).
Parameter:
<enable>
0 - reporting disabled (default)
1 - reporting enabled
#CALLSTAT: <call_id>,<stat>
where
<call_id>
- indicates the call identification (GSM02.30 4.5.5.1)
<stat>
- indicates the voice call status as follows
0 - active
1 - hold
2 - dialling (MO call)
3 - alerting (MO call; ringing for the remote party)
4 - ringing (MT call)
5 - waiting (MT call)
6 - disconnected
7 - connected (indicates the completion of a call setup first time for MT and MO
calls - this is reported in addition to state active)
AT#CALLSTAT?
Read command reports the current value of the parameter.
