HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 128 of
229
+CMSS - Send Message From Storage
+CMSS: 136
OK
Reference
3GPP TS 27.005
3.5.4.4.3.
Write Message To Memory - +CMGW
+CMGW - Write Message To Memory
(PDU Mode)
AT+CMGW=
<length>
[,<stat>]
(PDU Mode)
Execution command writes in the
<mem2>
memory storage a new message.
Parameter:
<length>
- length in bytes of the PDU to be written.
7..164
<stat>
- message status.
0 - new message
1 - read message
2 - stored message not yet sent (default)
3 - stored message already sent
The device responds to the command with the prompt '>' and waits for the
specified number of bytes.
To write the message issue
Ctrl-Z
char (
0x1A
hex).
To exit without writing the message issue
ESC
char (
0x1B
hex).
If message is successfully written in the memory, then the result is sent in the
format:
+CMGW: <index>
where:
<index>
- message location index in the memory
<mem2>
.
If message storing fails for some reason, an error code is reported.
Note: care must be taken to ensure that during the command execution, no other
SIM interacting commands are issued.
(Text Mode)
AT+CMGW[=<da>
[,<toda>
[,<stat>]]]
(Text Mode)
Execution command writes in the
<mem2>
memory storage a new message.
Parameters:
<da>
- destination address, string type.
<toda>
- type of destination address.
129 - number in national format
145 - number in international format (contains the "
+
")
<stat>
- message status.
"REC UNREAD" - new received message unread
