HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 182 of
229
#DBGS – Debug screen command
<ciphering>
- ciphering dis-/enabled (0/1) (can only be changed via Phonetool)
<integr_prot>
- integrity protection dis-/enabled (0/1) (can only be changed via
Phonetool)
AT#DBGS? #DBGS:
<mode>,<page_nr>
where:
<mode>
- see before
<page_nr>
- see before
AT#DBGS=?
Test command returns all supported values of the parameter.
3.5.5.1.55.
Display PIN Counter - #PCNT
#PCNT - Display PIN Counter
AT#PCNT
Execution command reports the PIN/PUK or PIN2/PUK2 input remaining attempts,
depending on
+CPIN
requested password in the format:
#PCNT:
<PIN attempts>, <PIN2 attempts>, <PUK attempts>, <PUK2 attempts>
where:
<PIN attempts>
- PIN1 remaining attempts
<PIN2 attempts>
- PIN2 remaining attempts
<PUK attempts>
- PUK1 remaining attempts
<PUK2 attempts>
- PUK2 remaining attempts
0 - the SIM is blocked.
1..3 - if the device is waiting either SIM PIN or SIM PIN2 to be given.
1..10 - if the device is waiting either SIM PUK or SIM PUK2 to be given.
AT#PCNT=?
Test command returns the OK result code.
3.5.5.1.56.
Query SIM Status - #QSS
#QSS - Query SIM Status
AT#QSS=
<mode>
Set command enables/disables the Query SIM Status unsolicited indication in the
ME.
Parameter:
<mode>
- type of notification
0 - disabled (factory default); it’s possible only to query the current SIM status
through Read command
AT#QSS?
1 - enabled; the ME informs at every SIM status change through the following
unsolicited indication:
#QSS: <status>
where:
<status>
- current SIM status
0 - SIM NOT INSERTED
