HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 31 of 229
+FCLASS - Select Active Service Class
8 - voice
AT+FCLASS?
Read command returns the current configuration value of the parameter
<n>
.
AT+FCLASS=?
Test command returns all supported values of the parameters
<n>
.
Note
“ATD<number>;” (end with semicolon) will initiate voice call no matter which
connection mode is set by +FCLASS.
Reference
3GPP TS 27.007
3.5.2.1.4.
Default Reset Basic Profile Designation - &Y
&Y - Default Reset Basic Profile Designation
AT&Y[<n>]
Execution command defines the basic profiles which will be loaded on startup.
Parameter:
<n>
0..1 - profile (default is 0): the wireless module is able to store 2 complete
configurations (see
&W
).
Note: differently from command
Z<n>
, which loads just once the desired profile,
the one chosen through command
&Y
will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as
AT&Y0
3.5.2.1.5.
Default Reset Full Profile Designation - &P
&P - Default Reset Full Profile Designation
AT&P[<n>]
Execution command defines which full profile will be loaded on startup.
Parameter:
<n>
0..1 – profile number: the wireless module is able to store 2 full configurations
(see command
&W
).
Note: differently from command
Z<n>
, which loads just once the desired profile,
the one chosen through command
&P
will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as
AT&P0
Reference Telit
Specifications
3.5.2.1.6.
Store Current Configuration - &W
&W - Store Current Configuration
AT&W[<n>]
Execution command stores on profile
<n>
the complete configuration of the device.
Parameter:
<n>