Telguard TG-1 Express CDMA, Installation And Operating Instructions Manual

Page: 24 / 26

56050801 - Rev B 18 © 2017 Telguard
Troubleshooting Quick Reference Table
Telguard Event LED Indication Relay
Output Radio
Message Internal Action
STC
Telguar
d System
Trouble
Conditi
ons ACFC AC LED off. STC LED 2
flashes continuously 1
time.
Option
al None Switch to standby
battery if present,
monitor battery,
monitor AC for
restoral.
LBC STC LED 2 flashes cont.
2 times .
Option
al None Wait for LBC restoral,
charge battery.
NSC STC LED 2 flashes cont.
4 times.
Option
al None Continue to validate
signal strength, NSC
will restore when
signal returns.
RFC STC LED 2 flashes cont.
5 times .
Option
al None Wait for RFC restoral.
DTF -
Dial Tone
Failure STC LED 2 flashes cont.
6 times .
Yes Yes Internal 30V supply
circuit failure.
PPF STC LED 2 flashes cont.
7 times.
No Yes Wait for PPF restoral.
Not Activated Activation LED 1 off. Yes None The Telguard will not
function until the
first signal is sent
through the Telguard
to activate the unit
Automatic Self-Test Radio LED 5 flashes
during transmit.
None Yes (Self-
test) Send Self-test
information to central
station via TCC,
return to ready state.
Telguard Remote Query
– Communication
Center Activated by
Customer Service. Radio LED 5 flashes
during transmit.
None Yes (Status
data) Send Status data to
the TCC for review
customer service.
Telguard Enable and
Configuration Upload
– Radio LED 5 flashes
during transmit.
None Configurati
on Data
(Setup
data) The Telguard sends
setup configuration to
the TCC and switches
to READY state to
begin operation.
Disable TX –
Communication Center
initiated. Radio LED 5 flashes when
transmitting.
Yes Yes (Status
data) TX capability is
disabled until further
notice.
The Telguard
can still receive
radio signals from the
TCC.
Note: If several trouble conditions are present, the STC LED will flash all of the
indications in sequence.