SYSTEM WALK-THRU
Now that you have successfully “set up” your
TELEX Wireless Intercom System and turned
on any auxiliary equipment you are ready to
test the overall performance by “Walking” the
TELEX system through the areas in which you
will be using it.
Before you begin your walk-thru check the fol-
lowing:
TR-200 Battery Check.
Set microphone gain in both the TR-
200 and the BTR-200.
Check the push-to-talk switch is
engaged in the Lock-to-talk position.
LED will be illuminated.
Only portable units to be used are en-
abled at the Base.
The “system walk-thru” can detect problems of
weak signal strength caused by:
·
Poor antenna location
·
Wrong antenna for receiver and/or trans-
mitter.
·
RF “Trouble Spots”
·
Operating distance beyond system
capability.
·
Old or used batteries in the TR-200
Under normal conditions the portable carrier
indicator LEDs
on the BTR-200 should always
be lit when portables are transmitting. “Weak
Signal” conditions will result in flashing of the
Carrier LED.
In 99% of all instances you will set up your
TELEX Wireless Intercom System, walk it
through and achieve error-free performance. If
in the rare instance your TELEX System does
not “pass” during your walk-thru evaluation,
refer to the last section of this manual which
deals with System Troubleshooting.
-33-
