TP2000 Transmitter
-
Installation and Operation Manual
17
With choosing the
Physical reloc.
combo-box you can program transmitting of input
messages to a relevant frequency - Frequency 1, Frequency 2 or to both of them.
The numbers of the inputs are situated vertically. The frequencies are situated horizontally
thus are specified two columns – for Frequency 1 and Frequency 2. A mark in the
combo-box next to the relevant input means that the messages will be transmitted by
the relevant frequency (frequencies). It is possible the input messages to be transmitted
by Frequency 1, Frequency 2 to the both of them. The priority of the frequencies in the
transmitting is automatically determined.
If you wish to use one transmitter for two sites you can specify their addresses in the
address1
and
address 2
fields and set up a link with the corresponding logical channels
for each of them.
After modifying the values on the fields press
button for the changes
to be updated, or
button to discard them and keep the old settings.
Note:
In order to be able to choose between the two frequencies you first have to check
in the box of the
Fx2
(Enabling of Frequency 2)
in the
radio
tab,
Frequency
field.
Otherwise the fields in the column of
Frequency 2
will not be available, see Figure 13.
Figure 13.
enabling of Frequency 2.
2.2.3.2 Serial connection with CA60Plus
alarm system for transmitting of zone information
Connect the green interface cable of the
Ca60Plus
control panel to the AC input of the
TP2000 Transmitter
. Thus you will make a serial connection between them – see also
Figure 14.
Figure 14.
serial
connection
between
Ca60Plus
Control
Panel and
TP2000
Transmitter.
Summary of Contents for TP2000
Page 23: ...PALM PROGRAMMATOR OPERATION MANUAL ...
Page 35: ... NOTES ...
