Teletek electronics iRIS8, Engineer Programming Manual

Page: 23 / 87

iRIS8 - Addressable Fire Alarm Panel
– Installer Programming
23
3.2.8. Loop Devices
– SensoIRIS Devices Settings
For all SensoIRIS devices are available additional settings after pressing button MORE. The additional settings vary
according to the type of device. The following fields are common in the settings for all devices:
Field Description
LED BLINK
Using this button, the installer can enable or disable the LED indication showing the
communication between the panel and the respective device. When setting ON state, the LED of
the device starts blinking at every 10 seconds in normal operation mode.
Note: SensoIRIS devices MINP M, WSOU, WSOU IS, BSOU and BSOU IS have no LED
indication for showing the communication with the panel.
SOFTWARE
REVISION
In the field is shown the current software revision of the device.
ID
In the setup menu of every device is introduced a system ID field with a unique 10-digit number
– the ID number of the device for identification in the system configuration.
Refer to the individual installation manuals of SensoIRIS devices for detailed information about their technical
specifications, mounting, etc.
3.2.8.1. Optical-Smoke Detectors
Available models:
•
SensoIRIS S130
– optical-smoke detector, white (available also in black)
•
SensoIRIS S130 IS
– optical-smoke detector with built-in isolator module, white (available also in black)
For detailed description of the main screen of the device
see item
3.2.6 . Press MORE button to access some
additional settings.
At the device settings screen the installer can review the general and set some additional parameters:
Smoke [%] /
Temperature [
° C]
Press the “Check” button to enter in a new screen to review the following parameters:
- Smoke [%]: Shows in percent the current level o
f smoke in the detector’s smoke chamber.
-
Pollution [%]: Shows in percent the current level of pollution in the detector’s smoke
chamber.
Day Alarm Level Setting the day alarm level*.
Night Alarm level Setting the night alarm level*.
* NOTE: The currently set alarm level is displayed with small asterisk sign at the end of the field.
There are 4 levels for setting of alarm level sensitivity:
High, Normal, Middle and Low. To change the level of
sensitivity simple press the active button next to the field
and choose a new level from the list.
To save the new setting, press EXIT button to return to the
main screen of the device and press APPLY button on the
top of the screen.